Please see attached picture of ADuM240D waveforms as C1(yellow):input and C2(blue):output. It seems that the duty cycle is changed and the high level is also changed from 3.4V to 3.2V. Its frequency is 50kHz and ADuM240D must be available between DC to 150Mbps. Could you please give me any information to improve?
Good power supply quality is very important for isolator to work properly. Another point i would suggest is the connection of DISABLE pin. although there is pull down inside, but its strength is weak. Short it to GND1 is a better choice.
Thank you very much for your support. It have been improved by shorting DISABLE pi to GND1 pin. The customer would like to know why it have been done and the inside equivalent schematic around DISABLE pin. Could you please let us know?
Sorry for my pushing, The customer needs the structure of DISABLE pin.
I'm in Shanghai to have ATS2018 FAE Training. If you join it, I'd like to communicate with you.
i will be at ATS tomorrow afternoon. you could find me at the demo area.
i am touching the designer for this.
I have an additional question about ADuM240D.
The customer doesn't use Input C and Input D. When these pins are pulled up, the case temperature rise up to 120degC. On the other hand, when pulled down, it is 25degC.
Could you please let me know the reason of the temperature issue ?