Is it possible to share EFT data with ADIN1200

Hi,

The data referred to in the above link is referring to simulation EFT data for a specified cap coupling use case. For access to measurement reports, these can be shared directly once there is an NDA in place.

Best Regards,

Mark

Hi,

Datasheet is written below magnetics, but HX1260NL doesn't have auto transformer.

we would like to do EFT using auto transformer magnetics. therefore, if you have recommendation about magnetics, please let me know.

because we were tried to test NECA TR-28, but it was failed. so we want to same test again after change magnetics.

Best regards

Hi,

Thank you for pointing out this correction in the ADIN1200 datasheet relating to the HX1260NL section. This transformer that is mentioned, the HX1260NL, is the transformer that is used on the Eval Kit and is the recommended transformer for use with the ADIN1200. The ADIN1200 is an Industrial Ethernet PHY, and we do not have a specific Auto grade transformer to recommend, however, transformers that are compliant with the IEEE802.3 Standard should be compatible with the PHY.

Best Regards,

Mark

Hi,

Thank you for pointing out this correction in the ADIN1200 datasheet relating to the HX1260NL section. This transformer that is mentioned, the HX1260NL, is the transformer that is used on the Eval Kit and is the recommended transformer for use with the ADIN1200. The ADIN1200 is an Industrial Ethernet PHY, and we do not have a specific Auto grade transformer to recommend, however, transformers that are compliant with the IEEE802.3 Standard should be compatible with the PHY.

Best Regards,

Mark