FIDO5200 Transmit packet continued

Hello,

So let's walk through this.

The first question to ask is for your schematic and what kind of processor is being used. 

Do you have your schematic for this design?

Also, can you tell me what part of the world you are in and what company you are with?

Thank you very much.

Best Regards,

I am French and I work for the company Vedecom. I use the FIDO because I need to connect in Ethernet a power converter.

My design is an MCU F28379D connected to the FIDO5200 by the EMIF device (external memory interface) as indicated in the AN-1554 documentation. The FIDO is also connected to 2 PHY of the DP83848-EP from Ti.

Via the MCU I can communicate with the FIDO, I can write and read in the different registers (direct and indirect).
So I started to use the REM switch driver, I followed the documentation and used the functions init, mac, port and speed.
I can see that the registers that are concerned by these functions have changed. Then I try to send a message using the different sending functions possible but nothing happens.
I observe with the oscilloscope that the FIDO doesn't send any signal to the PHY component and that those it receives from the PHY via the RX pins of the MII interface have no effect (no interrupt, no message in memory)

I try to look if the initialization is well done, the functions init, mac, port and speed did not return any error. I don't know what are the most important registers/bits to check to be sure that the FIDO can make a communication ?

 Best Regards

Hello, 

Thank you for that insight. One of the things that can also come into play is making sure your PHYs are configured correctly for this application.

Can you please walk me through what you are doing to initialize the PHYs? 

Please let me know on this as this can be tiricky to get right.

Also, can you walk me through what happens when you are debugging the code and you hit "REMS_STDIinit()"?

Thank you very much.

Best Regards,

For the configuration of the PHY module, it is configured with auto-negotiation at reset. When it is connected to another device, the speed and duplex are set automatically. I retrieve this information via the MDIO communication of the PHY and I configure the speed and duplex of the FIDO using these parameters.

I can see in the PHY registers that the linking is OK. Is it possible to see in a register of the FIDO that the linking is also completed ?

For the configuration of the PHY module, it is configured with auto-negotiation at reset. When it is connected to another device, the speed and duplex are set automatically. I retrieve this information via the MDIO communication of the PHY and I configure the speed and duplex of the FIDO using these parameters.

I can see in the PHY registers that the linking is OK. Is it possible to see in a register of the FIDO that the linking is also completed ?