Hi,
We are planning to use the FIDO5200 for 100 Mbps EtherCAT interface.
Could you please provide the Evaluation Schematic along with PHY.
Also please suggest the Recommended PHY device for this device.
Thanks and Regards,
Reshma.
FIDO5200
Recommended for New Designs
The fido5100 and fido5200 (REM switch) are programmable IEEE 802.3 10 Mbps/100 Mbps Ethernet Internet Protocol Version 6 (IPv6) and Internet Protocol Version...
Datasheet
FIDO5200 on Analog.com
Hi,
We are planning to use the FIDO5200 for 100 Mbps EtherCAT interface.
Could you please provide the Evaluation Schematic along with PHY.
Also please suggest the Recommended PHY device for this device.
Thanks and Regards,
Reshma.
Hi Reshma,
Sorry for the delay. Do you have ADI Chronous Developer Portal Access? If so please let me know and I can advise you where to go for schematics used for interfacing with the fido5200. Otherwise I will give you instructions on how to register for the Developer Portal.
Hi,
Would you please give me instructions on how to register for the Developer Portal? I have tried to register for many times but it didn't work.
Thanks and Regards,
Anaty
i have access and created teh account, please do send the link fro Fido5200 schematics and the bootloader download
Hi,
would you please tell me some key to access or create an teh account?
thank you
Hello,
Please refer to the following EngineerZone thread for information on how to create a Developer Portal Accound.
(6) Industrial Ethernet Switches - Q&A - Embedded Ethernet Switches - EngineerZone (analog.com)