Category: Hardware
Product Number: AD9083
We're evaluating the AD8093 for a new design, so we attached the AD9083EBZ to our custom board (i.o.w. not the zcu102). This board so far worked fine with any FMC add-on we've used.
When I plug the AD9083EBZ into the FMC and power-on the system, it yields a worrying buzzing noise, as if some DC convertor is being maltreated.
The FPGA pins at this stage are all tri-stated, there's no logic driving them (yet).
I'll try to borrow a zcu102 board to see if the evaluation board is just DOA. Any comments from your side?
