Operating two FMCOMMS8 simultaneously on ZCU102

Hi,

Regarding the available resources, it should be possible to integrate another FMCOMMS8 on the second FMC HPC. In order to do that, I suggest using our fmcomms8/zcu102 as a starting point and adding the logic for the other FMC on top of it. There are some tips in this guide that might help you.

Regarding the synchronization of the RF chips, I'm not sure yet if it is possible, but we will look into it.

Best regards,

Andrei

Hello AndreiDragomir 

Thank you for your reply. I was reviewing ZCU102+FMCOMMS8 and ZCU11EG+FMCOMMS8 design. In the later one, as it is a custom ADI designed board with MPSoC, MIG controller had 256 bits as AXI read and write data length while ZCU102 MIG had 128 bits. So, I have to consider that if the MIG controller extend the AXI size or not in ZCU102. Will notify you if there is some other HDL questions.

Thank you.

Regards,

Hello AndreiDragomir 

Thank you for your reply. I was reviewing ZCU102+FMCOMMS8 and ZCU11EG+FMCOMMS8 design. In the later one, as it is a custom ADI designed board with MPSoC, MIG controller had 256 bits as AXI read and write data length while ZCU102 MIG had 128 bits. So, I have to consider that if the MIG controller extend the AXI size or not in ZCU102. Will notify you if there is some other HDL questions.

Thank you.

Regards,