ADRV9002 Profile

Hi Elliott,

Can you try loading the profile from the Linux terminal:  

e.g. 

cat /home/analog/fdd_64kps_2_channel.bin > /sys/bus/iio/devices/iio:device1/stream_config
cat /home/analog/fdd_64kps_2_channel.json > /sys/bus/iio/devices/iio:device1/profile_config

adjust  iio:devicex to point to the  adrv9002-phy device

If that does not work please can you share the profiles ? 

Thanks, 

Laszlo

Hi Laszlo,

I am now working on this instead of Elliott.  I am brand new to NextGen RF so bear with me.  On the dev kit there are no bin files you reference in your message.  Are you suggesting I SCP our profile/stream to the dev kit and run the cat commands?

Thanks,

Dan

ADRV9002.zipHi Laszlo,

I SCP-d the profile and stream to the dev kit with the following results.

• cat profile to iio:device0, iio:device2 or iio:device3 result: permission denied
• cat profile to iio:device1 result: cat: write error: Bad address

I have attached the profile and stream files

If you are using TES v0.14 it will require the 2019-R2 release. Which version are you using?

Does dmesg output anything after trying to load the profile?

-Travis

Can you share a link for TES suitable for 2019?

The dev kit is running

• boot_2019_r1_2020_06_22
• hdl_2019_r1
• Linux Intel 2019_R1_altera
• Linux Xilinx 2019_R1

Pre-release SD card is here: https://github.com/analogdevicesinc/hdl/releases/tag/hdl_2019_r2

-Travis

Using the Pre-release SD card content the dev kit will not boot.

Can you provide the boot log?

-Travis

I cannot get the boot log, it never boot.  The monitor connected only showed a blinking cursor in the upper left corner.

These dmesg's are after booting with our 2019.R1 SD card.

dmesg.zip

What comes out UART from power on?

-Travis