Porting AD-FMCOMMS3 ZCU102 HDL reference design to some other board

Hi All,

I have AD-FMCOMMS3-EBZ evaluation board and I have previously used it with KCU105. I used the HDL reference design and the No-OS software provided on github, for this task. 

Now I have to interface AD-FMCOMMS3-EBZ with the board provided by Trenz Electronics.

This is the baseboard that I will be using: https://shop.trenz-electronic.de/en/TEBF0808-04A-UltraITX-Baseboard-for-Trenz-Electronic-TE080X-UltraSOM 
and this is the SOM: https://shop.trenz-electronic.de/en/TE0808-04-09EG-2IE-UltraSOM-MPSoC-Module-with-Zynq-UltraScale-XCZU9EG-2FFVC900I-4-GB-DDR4

So my plan is to use the ZCU102 HDL reference design and then modifying it so that I can make it work on the new hardware.

I want to make sure that this is possible before purchasing the hardware.

So far from what I have seen, this looks possible as FPGAs are same, FMC_HPC is available and the DDR4 also provide same data width and storage capacity.

Please provide me with expert opinion. Will this be possible? and what should I make sure to confirm this?

And what challenges should I expect while porting the design to the given hardware.