ADE9153ASHIELDZ ESP32 communication

https://github.com/sensidev/STM32-B-L072Z-poc/blob/master/Core/Src/ade9153a_spi.c

Here is some code showing how to do this using STM32 you will need to create something that will work with the esp32. Every micro has a different way to configure spi so it is difficult to create this for every part. 

Dave

Thank You so much for your response I'll go through the link provided by you and get back to you in case of any difficulty

Pratham 

Hi Dave i adjusted/rewrote the software as per my requirements for ESP32 however after making all the necessary connection pertaining to SPI connection as per the operation manual provided on website,I'm still unable to power up the board (on board LEDs are not glowing) should i be providing any seperate 5V supply from esp32 to the evaluation board ? 

Thank you

Pratham

You need to make sure power is getting from the ESP side to the hot side.

Check the voltages here if they are not there 

Check here 

v

Hi Dave figured that out thanks for the response.

Also Im currently facing issue with the following temperature readings: 

trim value : -1846987330
gain value : 13758
offset value : 37353
Temp_reg_value : 3343
Temperature: 816.38 °C

it is obviously very high temperature value any clue why ? 

Thank You in advance 

Pratham

These numbers don't appear correct 

1. could you read back teh Vlevel after reset is it 45D450 with run bit set 

2. is the run bit set when you are doing this? 

3 can you verify you are getting -1846987330  on a scope? I would cast this as a uint32_t which I think is 91E9 35BE

Dave