Post Go back to editing

Calibration

Category: Hardware

Hello:

After having the ADE9000 calibration session, another measurement that is needed is the accumulated energy. We ran power measurement tests, using the evaluation card and evaluation software we are only able to accumulate 1.04 seconds. The measurement of accumulated energy for one second was carried out without problems. However, we need an accumulation of at least 1 minute.

In the ADE9000 Technical Reference Manual UG-1098 there is a configuration to accumulate energy for 106 seconds. An attempt was made to configure it but it was not possible

Do you have any idea what could be going wrong?