I'm using a couple of LTC4222 to provide power to scientific sensors.
Because i don't fully understand the workings of this chip (yet) i'm stumped as to why one sensor keeps tripping it.
The device uses 12V 600mA nominal and i took all the component like the example in the datasheet for 12V.
Using a current probe the measured maximum current spike at startup (of the device) was 2,25A.
I tried using a sense resistor for 6A instead but the result is the same.
I tried increasing Ctimer to 10µF to no avail.
What am i overlooking or should i check?
