Development is in progress using ADE9000.
I want to re-set VC and IC using ADC_REDIERCT register (refer to ADE9000_UG_1098)
and I set the setting value as follows, but it does not work.
How do I set ADC_REDIRECT?
I am trying to figure out what you are doing. RE-SET? just write 0x1FFFFF
By default 0x001FFFFF each adc goes to to expected path. Why did you have to change from 111 to 010 IC and 111 to 110 VC should have the same result. if you set back to 1FFFFF does everything work fine?
Thank you for answer.
We want VC and IC settings for single phase.I made the following settings by referring to the manual, but it does not work.ADE9K_Write32(0x00000424,0x001BFEBF);==>b110111111111010111111=0x001BFEBF(UG1098 77Page)
I want to know if I need to initialize at ADE9K_Write32(0x00000424,0x001FFFFF) and to set VC and IC??.
Can you explain the adc routing you are trying to do.
If you wanted 3 single phase circuits using one voltage channel
You would want
Va to go to Vb and VC Each current sensor stays the same
VA * IA
VA * IB
VA * IC
each current is derived from a different load on VA
A diagram of your connections might help
Thank you for the reply.
I want to set the VC voltage to apply to IA, IB and IC. Can I set the register as follows?
ADE9K_Write32(0x00000424,0x001BFE88);//110 111 111 111 010 001 000=0x001BFE88
sorry I need to clarify
you want VC * IA and VC * IB and VC * IC
or IA=VC IB=VC and IC= VC don't know why you would do this?
Write ADC_REDIRECT TO