Would like to connect shunt resistor on neutral path to measure only neutral current of ADE9153A. Could anyone please verify the below connections are correct.
There is no issue with putting the shunt on the Neutral line as long as the ground reference is switched as well, which it looks like you did change so that the Neutral is the ground for the ADE9153A while the Live goes to the potential divider only.
There is a schematic in one of the documents that has an incorrect resistor value, please change R3 and R5 to 150Ohms instead of 150kOhms. Other than that, your schematic looks to be OK.
Thank you, i will correct the R3 and R5 resistor value to 150 Ohms.
Could you please share the source code of ADE9153A.