VisualDSP++ problem with connection to 21469 EZ-KIT

Hi,

As you are using SADA2(Debug Agent) with VisualDSP++, pins 1&2 of JP1 should NOT be populated (OFF).

When 1&2 of JP1 are NOT populated, the SADA 2 should appear in the Device Manager under ‘ADI Development Tools’.

If 1&2 of JP1 are populated, and connection to a target is attempted with VisualDSP++, the following error will be reported:

Error: 0x80048015
Error Description: Initialization: Open Device Failed

Please note that, When installing or removing the jumper, the USB cable should be disconnected from the emulator, or unplugged and plugged in again after the jumper has been changed.

Please refer the below FAQ for more information:
ez.analog.com/.../faq-can-t-connect-to-target-via-emulator-after-upgrading-to-cces-1-1-0

Regards,
Nishanthi.V

Hi,

You can refer the attached image.

Regards,
Nishanthi.V

Hi again,

thank You so much.

Now it works 

I'm sorry for I was not able to find the appropriate FAQ myself.

Of course I searched for help, a document or a post .. but was not successful.

Unfortunately my search did not contain the needed words.

It's allways hard to find something where you don't know the name or the wording.

Anyway, many thanks for your support.

Best regards

Hi again,

thank You so much.

Now it works 

I'm sorry for I was not able to find the appropriate FAQ myself.

Of course I searched for help, a document or a post .. but was not successful.

Unfortunately my search did not contain the needed words.

It's allways hard to find something where you don't know the name or the wording.

Anyway, many thanks for your support.

Best regards