Post Go back to editing

The Peak Compressor in SigmaStudio+ behaves unstably when compressing signals on the ADSP-21565.

Thread Summary

The user reported an issue with the Peak Compressor in SigmaStudio+ where the output signal drops unexpectedly when the input is increased beyond a certain threshold, unlike the stable behavior in the RMS Compressor and the Peak Compressor on the ADAU1466. The issue has been confirmed and is planned for a fix in the v3.5.0 release. The user used a 1 kHz sine wave for testing and confirmed the input signal stability, suggesting the problem lies in the compressor's internal gain calculation logic.
AI Generated Content
Category: Software
Product Number: adsp-21565
Software Version: sigma studio+ 3.4.0

1.As seen in the picture, no compression is being applied yet.

2.After I set the compression threshold to about -15 dB, the output signal is clearly being limited when I compare it to the input.

3.When I turn up the input by 1 dB, the output goes up by 1 dB as well.

4.When I raise the input by 2 dB, the output actually drops by 1 dB.

5.From then on, each 1 dB input boost gives me 1 dB more output. But every time the input goes up by 3 dB, the output suddenly crashes down to my set threshold.

What's going on here? I don't see this problem with the RMS Compressor, and the Peak Compressor on the ADAU1466 doesn't behave like this either—it stays stable the whole time.

Thread Notes

Parents Reply Children
No Data

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.