Linux for ADSP-SC5xx processors

Q&A NOR-flash programming in production

Thread Details

State Not Answered
Replies 1 reply
Subscribers 11 subscribers
Views 488 views
Users 0 members are here

Options

NOR-flash programming in production

StijnVM

on Nov 30, 2020

Hi,

We're looking in to a good way to program the NOR flash on our custom SC587 board in production.

Do you have any simple Windows GUI tools for this?

Right now we're looking into using J-link and their SPI programming tool: https://www.segger.com/products/debug-probes/j-link/tools/j-flash-spi/
Is this supported on the SC58x series?

Thanks a lot!

jtag adsp-sc58x

Parents

MurrayA

on Dec 1, 2020 5:02 PM
0
Hi StijnVM,

we have a "CrossCore Serial Flash Programmer Utility" as part of the CrossCore Utilities (available here: https://www.analog.com/en/design-center/evaluation-hardware-and-software/software/crosscore-utilities.html).
This provides a graphical way to program the flash chips on the evaluation kits (SC584 or SC589 in this case), rather than being a generic tool, so you'd need to modify the driver in order to program any other flash devices.

Regards,
Murray
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Reply

MurrayA

on Dec 1, 2020 5:02 PM
0
Hi StijnVM,

we have a "CrossCore Serial Flash Programmer Utility" as part of the CrossCore Utilities (available here: https://www.analog.com/en/design-center/evaluation-hardware-and-software/software/crosscore-utilities.html).
This provides a graphical way to program the flash chips on the evaluation kits (SC584 or SC589 in this case), rather than being a generic tool, so you'd need to modify the driver in order to program any other flash devices.

Regards,
Murray
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Children

No Data