2005-06-18 08:54:21 how load and compile the uClinux kernel
rashmi c (INDIA)
Message: 2736 hi,
I am loading linux.dxe through kermit to stamp board it saves it in ram.
when say
bootelf 0x01000000
## start adderess 0x00001000
text
...
bss
then hangs
what could be the reason ?
can anybody tell me the procedure load and get the shell prompt for uClinux?
regards
rashmi
QuoteReplyEditDelete
2005-06-18 09:25:21 RE: how load and compile the uClinux kernel
Aubrey Li (CHINA)
Message: 2737 Did you try the "linux" file in the RC1_june_2005 release?
Would you please post the startup messages in the kermit?
QuoteReplyEditDelete
2008-07-17 06:24:29 Re: how load and compile the uClinux kernel
suresh kumar (INDIA)
Message: 59011
use TFTP sever
then dump to kernal into target through ethernet.
QuoteReplyEditDelete
2008-07-17 08:54:45 Re: how load and compile the uClinux kernel
Mike Frysinger (UNITED STATES)
Message: 59015
this thread is over three years old ... please dont respond to such old ones