2011-06-12 13:02:54 uCasterisk BF533-STAMP problem
Łukasz Nowakowski (POLAND)
Message: 101222
Hello,
I'm trying to run uClinux (version 2006R1), modified with uCasterisk-0.1.7 on my BF533-STAMP to use 1 FXS-port module. Unfortunately when I try uCasterisk scripts or "make bin" command, I always get such an error msg on my STAMP:
Using bfsi.bofsi: version magic '2.6.16.27-ADI-2006R2 gcc-4.1' should be '2.6.16.11.ADI-2006R1blackfin gcc-3.4'
insmod: cannot insert `': Invalid module format (-1): Exec format error
Using zaptel.ko
Zapata Telephony Interface Registered on major 196
Using wcfxs.ko
wcfxs: Unknown symbol _bfsi_sport_init
wcfxs: Unknown symbol _bfsi_sport_close
wcfxs: Unknown symbol _bfsi_spi_read_8_bits
wcfxs: Unknown symbol _bfsi_spi_write_8_bits
wcfxs: Unknown symbol _bfsi_spi_init
wcfxs: Unknown symbol _bfsi_reset
insmod: cannot insert `': Unknown symbol in module (-1): No such file or directory
Notice: Configuration file is /etc/zaptel.conf
line 147: Unable to open master device '/dev/zap/ctl'
No entry for terminal type "dumb";
using dumb terminal settings.
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
init: Booting to single user mode
BusyBox v1.00 (2011.06.12-13:48+0000) Built-in shell (msh)
Enter 'help' for a list of built-in commands.
root:~>
Any idea how to solve this problem ?
Sincerely,
Łukasz Nowakowski
QuoteReplyEditDelete
2011-06-13 15:20:02 Re: uCasterisk BF533-STAMP problem
Mike Frysinger (UNITED STATES)
Message: 101234
sorry, but that release/project is no longer supported here. please try the asterisk forums:
blackfin.uclinux.org/gf/project/asterisk/forum/
QuoteReplyEditDelete