2008-07-22 10:23:47 [PPI problem] No signals output
Axel Normand (FRANCE)
Message: 59226
Hello,
I have make my own blackfin card based on BF533_STAMP.
uClinux run well on it. I can used ethernet link and use my program. But, my screen driver dont run on it !
My LCD driver run on bf533_stamp. On my board, I juste see good timer for V sync and H sync, but I can't see any data on the PPI. Some bits are at 0 and other at 1.
I think my PPI Clk is good because I have the différente timer.
The diference betwen the 2 card is the revision of Blackfin 0.5 for mine and 0.3 for stamp and I used a tqfp package.
My driver do it's initialisation well and dont detect any problem on PPI.
If, anyone have an idea where the error come from.
regard's Axel
TranslateQuoteReplyEditDelete
2008-07-22 10:37:32 Re: [PPI problem] No signals output
Andras Szemzo (HUNGARY)
Message: 59228
hi,
we run into this problem with BF532 0.4 and 0.5 rev.
On 0.5 rev, make sure your FS3 pin is connected to GND. Check the latest processor anomaly datasheet.
I hope this helps.
Regards,
Andras
QuoteReplyEditDelete
2008-07-22 11:06:20 Re: [PPI problem] No signals output
Axel Normand (FRANCE)
Message: 59232
Hi,
I connect FS3 to GND, it's run. Thank's.
I've not think to check the anomaly datasheet
Regards,
Axel