2008-10-10 02:20:43 No BF537-EZKIT available in make menuconfig...
Jere Mäkelä (FINLAND)
Message: 63368
I have two eval. boards: BF533 Stamp and BF537 EZ-kit. I updated uclinux to 533 board ok but now as I try to do the same with 537, I cannot get an option to select BF537-EZ-kit.
procedures:
root> make clean
root> make menuconfig
-> Select the Vendor...Only gives Analog Devices
-> Select the Product...Only gives BF533-STAMP
????
Jere
QuoteReplyEditDelete
2008-10-10 02:34:00 Re: No BF537-EZKIT available in make menuconfig...
Daniele Pagani (ITALY)
Message: 63369
Dear Jere,
I've the BF537-Ezkit too, and I can select the "BF537-STAMP" voice under "AnalogDevices Products".
I've the uClinux-dist-2008R1.5-RC3, so I think that you've not this release.
Please, update yours to this one.
Best regards,
Daniele.
TranslateQuoteReplyEditDelete
2008-10-10 03:09:46 Re: No BF537-EZKIT available in make menuconfig...
Yi Li (CHINA)
Message: 63373
You can build kernel for BF537-STAMP and run on BF537-ezkit. For difference of the two, please refer to: http://docs.blackfin.uclinux.org/doku.php?id=hw:boards:bf537-ezkit