2009-03-03 05:22:03 reduce resolution of cmos sensor if using BT.656 video interface
Blacky Fuchsberger (GERMANY)
Message: 70274
Hello,
I want to know, if a resolution of 1280 x 1024 pixels (e.g. PDS-24C1.3XDIG from Videology) is used,
how it is transmited over the video output if i set the output format to BT.656 ?
Will there be a reduction?, because i read at www.intersil.com/data/an/an9728.pdf that the maximum resolution of BT.656 is 720 x 576 pixels.
an9728.pdf
TranslateQuoteReplyEditDelete
2009-03-03 05:38:37 RE: reduce resolution of cmos sensor if using BT.656 video interface
Michael Hennerich (GERMANY)
Message: 70276 ITU-R 656 Modes are typically for 525/60 (NTSC) and 625/50 (PAL) video
systems.
Blackfin supports the bit parallel modes for ITU-R 656 framed data.
From a Blackfin point of view it is possible to set resolutions other
than for 525/60 (NTSC) and 625/50 (PAL).
If you have questions regarding features of a specific cmos sensor -
Read the sensor datasheet or contact the sensor vendor support.
-Michael