2009-03-20 02:31:47 how to manage nand flash through mtd
jacqueline liu (CHINA)
Message: 71293
hi ,
i've write my kernel and filesystem into the nand flash
but when i run the system as
root:\>cat /proc/mtd
there's only the infomation of parallel information
how could i manage nand flash using mtd
i've set the settings of nand flash part of mtd as below
Device Drivers --->
Memory Technology Device (MTD) support --->
NAND Device Support --->
<*> Blackfin on-chip NAND Flash Controller driver
[*] BF5XX NAND Hardware ECC
[ ] Use Blackfin BootROM ECC Layout
why can't i see the information of the nand flash through mtd?
thanks
TranslateQuoteReplyEditDelete
2009-03-20 06:12:50 Re: how to manage nand flash through mtd
Mike Frysinger (UNITED STATES)
Message: 71299
post the full output of your kernel booting