2009-07-22 07:30:01 HDD Mount
sree karan (INDIA)
Message: 77862
Hi,
##############################################################################
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
ide0: Blackfin generic IDE interface
Probing IDE interface ide0...
hda: probing with STATUS(0x50) instead of ALTSTATUS(0xaa)
hda: HTS541040G9AT00, ATA DISK drive
hdb: probing with STATUS(0x50) instead of ALTSTATUS(0xaa)
hdb: probing with STATUS(0x51) instead of ALTSTATUS(0xaa)
ide0 at 0x20100000-0x20100007,0x20118004 on irq 33
hda: max request size: 512KiB
hda: Host Protected Area detected.
current capacity is 78140160 sectors (40007 MB)
native capacity is 185074430006016 sectors (94758108163 MB)
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError }
ide: failed opcode was: 0x37
hda: 78140160 sectors (40007 MB) w/7539KiB Cache, CHS=16383/255/63
hda: cache flushes supported
hda: hda1 hda2
##############################################################################
I am trying to enable HDD driver in uClinux-dist-2008R1.5-RC3 kernel for the BF533 custom hardware.
Though I can mount, read from and write to the hard disk, I get some errors (highlighted in the above log).
What should be done to overcome those errors?
Kindly help.
Thanks in advance
Regards,
Karan
QuoteReplyEditDelete
2010-04-17 23:07:32 Re: HDD Mount
steven O (AFGHANISTAN)
Message: 88549
Hi ,
I have the same problem . had you solved it ? and how to solve it ?
QuoteReplyEditDelete
2010-04-21 11:44:39 Re: HDD Mount
Robin Getz (UNITED STATES)
Message: 88727
Steven:
Start a new thread.
-robin