2010-01-26 02:39:35 Userspace Init problems

Rob Maris (GERMANY)

Message: 85114

(also with reference to thread 38357)

Yesterday I updated my distribution to current SVN trunk (in a parallel distribution directory, up to now SVN 8023 was used). I took care of taking customizations from the "current" distribution, especially in vendor/....

Now my init gets stuck. However, I can FTP into the Blackfin module (TCM-BF537), and verify that the directory tree seems OK. Solely the JFFS2 formatted user directory isn't visible - due to not executed rc (note: rc is not set to executable, but the current distristribution isn't set to executable, too - while it operates OK).

The boot output shows no anomalies.

I need some hints where to look for other possible problems.

-Rob

QuoteReplyEditDelete

2010-01-26 02:45:48 Re: Userspace Init problems

Mike Frysinger (UNITED STATES)

Message: 85116

ive deleted your other posts then to avoid duplication

did you update your busybox config correctly ? you probably didnt select a shell (old was msh, new is hush and msh is dead).

QuoteReplyEditDelete

2010-01-26 02:57:06 Re: Userspace Init problems

Rob Maris (GERMANY)