[#4174] mount jffs2 as root fs fails to open init console on trunk now

Submitted By: Mingquan Pan

Open Date

2008-06-17 06:39:06 Close Date

2008-06-23 00:05:17

Priority:

Medium Assignee:

Mike Frysinger

Status:

Closed Fixed In Release:

N/A

Found In Release:

N/A Release:

Category:

N/A Board:

N/A

Processor:

N/A Silicon Revision:

Is this bug repeatable?:

Yes Resolution:

Fixed

Uboot version or rev.:

Toolchain version or rev.:

08r1-8

App binary format:

N/A

Summary: mount jffs2 as root fs fails to open init console on trunk now

Details:

mount jffs2 as root fs fails to open init console on trunk now.It looks something wrong in rootfs.jffs2.

bfin> bootm 0x20040000

## Booting image at 20040000 ...

Image Name: Linux-2.6.24.7-ADI-2008R2-pre-sv

Created: 2008-06-16 19:26:38 UTC

Image Type: Blackfin Linux Kernel Image (gzip compressed)

Data Size: 909128 Bytes = 887.8 kB

Load Address: 00001000

Entry Point: 00188000

Verifying Checksum ... OK

Uncompressing Kernel Image ... OK

Starting Kernel at = 188000

Linux version 2.6.24.7-ADI-2008R2-pre-svn4843 (test@uclinux51-ad9960-ad1836) (gcc version 4.1.2 (ADI svn)) #4 Tue Jun 17 03:26:31 CST 2008

console [early_BFuart0] enabled

early printk enabled on early_BFuart0

Warning: limiting memory to 56MB due to hardware anomaly 05000263

Board Memory: 64MB

Kernel Managed Memory: 64MB

Memory map:

fixedcode = 0x00000400-0x00000490

text = 0x00001000-0x00114f40

rodata = 0x00115080-0x00166124

bss = 0x00166140-0x00174d84

data = 0x00174d84-0x00188000

stack = 0x00186000-0x00188000

init = 0x00188000-0x001a3000

available = 0x001a3000-0x037ff000

DMA Zone = 0x03f00000-0x04000000

Hardware Trace Active and Enabled

Reset caused by Software reset

Compiled for ADSP-BF537 Rev 0.2

Blackfin Linux support by blackfin.uclinux.org/

Processor Speed: 500 MHz core clock and 100 MHz System Clock

NOMPU: setting up cplb tables for global access

Instruction Cache Enabled

Data Cache Enabled (write-through)

Built 1 zonelists in Zone order, mobility grouping off. Total pages: 14224

Kernel command line: root=/dev/mtdblock2 rw rootfstype=jffs2 earlyprintk=serial,uart0,57600

Configuring Blackfin Priority Driven Interrupts

PID hash table entries: 256 (order: 8, 1024 bytes)

console handover: boot [early_BFuart0] -> real [ttyBF0]

Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)

Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)

Memory available: 55084k/65536k RAM, (108k init code, 1103k kernel code, 461k data, 1024k dma, 7756k reserved)

Blackfin Scratchpad data SRAM: 4 KB

Blackfin Data A SRAM: 16 KB (15 KB free)

Blackfin Data B SRAM: 16 KB (16 KB free)

Blackfin Instruction SRAM: 48 KB (41 KB free)

Security Framework initialized

Mount-cache hash table entries: 512

net_namespace: 64 bytes

NET: Registered protocol family 16

Blackfin GPIO Controller

Blackfin DMA Controller

stamp_init(): registering device resources

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 2048 (order: 2, 16384 bytes)

TCP bind hash table entries: 2048 (order: 1, 8192 bytes)

TCP: Hash tables configured (established 2048 bind 2048)

TCP reno registered

JFFS2 version 2.2. (NAND) B) 2001-2006 Red Hat, Inc.

io scheduler noop registered

io scheduler anticipatory registered (default)

io scheduler cfq registered

Serial: Blackfin serial driver

bfin-uart.1: ttyBF0 at MMIO 0xffc00400 (irq = 18) is a BFIN-UART

RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize

bfin_mac_mdio: probed

bfin_mac: attached PHY driver [SMSC LAN83C185] (mii_bus:phy_addr=0:01, irq=-1, mdc_clk=2500000Hz(mdc_div=19)@sclk=100MHz)

bfin_mac bfin_mac.0: Blackfin on-chip Ethernet MAC driver, Version 1.1

physmap platform flash device: 00400000 at 20000000

physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank

Amd/Fujitsu Extended Query Table at 0x0040

number of CFI chips: 1

cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.

RedBoot partition parsing not available

Using physmap partition information

Creating 4 MTD partitions on "physmap-flash.0":

0x00000000-0x00040000 : "Bootloader"

0x00040000-0x00120000 : "Kernel"

0x00120000-0x003f0000 : "RootFS"

0x003f0000-0x00400000 : "MAC Address"

bfin-spi bfin-spi.0: Blackfin BF5xx on-chip SPI Controller Driver, Version 1.0, regs_base@ffc00500, dma channel@7

rtc-bfin rtc-bfin: rtc core: registered rtc-bfin as rtc0

bfin-wdt: initialized: timeout=20 sec (nowayout=0)

TCP cubic registered

NET: Registered protocol family 1

NET: Registered protocol family 17

rtc-bfin rtc-bfin: setting system clock to 1970-01-01 03:40:11 UTC (13211)

VFS: Mounted root (jffs2 filesystem).

Freeing unused kernel memory: 108k freed

Warning: unable to open an initial console.

Case 1 ...FAIL

JFFS2 TEST FAIL

Follow-ups

--- Mingquan Pan 2008-06-18 07:05:55

From the reversion I do, it looks the check-in of 6772 in uclist-dist of yaffs

result in this bug.

Does this checkin only affect yaffs?

--- Mingquan Pan 2008-06-19 04:24:11

I do the diff of 6771 and 6772,finding that:

--- vendors/config/bfin/config.arch (revision 6771)

+++ vendors/config/bfin/config.arch (revision 6772)

@@ -44,9 +44,9 @@

MKIMAGE = $(ROOTDIR)/$(LINUXDIR)/scripts/mkuboot.sh

MKFS_EXT2 = $(ROOTDIR)/user/genext2fs/build-host/genext2fs

MKFS_CRAMFS = $(ROOTDIR)/user/cramfs/host_build/mkcramfs

-MKFS_JFFS2 = $(ROOTDIR)/user/mtd-utils/build/mkfs.jffs2

-MKFS_YAFFS = $(ROOTDIR)/user/blkfin-apps/yaffs-utils/utils/mkyaffsimage

-MKFS_YAFFS2 = $(ROOTDIR)/user/blkfin-apps/yaffs-utils/utils/mkyaffs2image

+MKFS_JFFS2 = $(ROOTDIR)/user/mtd-utils/mkfs.jffs2

+MKFS_YAFFS = $(ROOTDIR)/user/yaffs-utils/mkfs.yaffs

+MKFS_YAFFS2 = $(ROOTDIR)/user/yaffs-utils/mkfs.yaffs2

And user/mtd-utils/mkfs.jffs2 diffs with user/mtd-utils/build/mkfs.jffs2, to

use the latter one doesn't make to work properly.

--- Mike Frysinger 2008-06-19 05:01:44

if that's the case, i'll take a look

--- Mike Frysinger 2008-06-20 11:19:39

should be fixed in svn now

--- Mingquan Pan 2008-06-23 00:05:17

Yes.Close.

Files

Changes

Commits

Dependencies

Duplicates

Associations