[#4712] It fails to record and play at the same time for ad73322

Submitted By: Vivi Li

Open Date

2008-12-10 05:42:47 Close Date

2008-12-15 04:00:02

Priority:

Medium Assignee:

Cliff Cai

Status:

Closed Fixed In Release:

N/A

Found In Release:

N/A Release:

Category:

Audio Board:

STAMP

Processor:

BF537 Silicon Revision:

Is this bug repeatable?:

Yes Resolution:

Not reproducible

Uboot version or rev.:

Toolchain version or rev.:

toolchain4.1_2008-11-13

App binary format:

N/A

Summary: It fails to record and play at the same time for ad73322

Details:

In bf537 with ad73322, it fails to record and play at the same time.

Bellow is the log:

Linux version 2.6.28-rc2-ADI-2009R1-pre-svn5849 (test@107-local) (gcc version 4.1.2 (ADI svn)) #2238

console [early_BFuart0] enabled

early printk enabled on early_BFuart0

Warning: limiting memory to 56MB due to hardware anomaly 05000263

Board Memory: 64MB

Kernel Managed Memory: 64MB

Memory map:

fixedcode = 0x00000400-0x00000490

text = 0x00001000-0x00122be0

rodata = 0x00122be0-0x001793f0

bss = 0x001793f0-0x00189934

data = 0x00189934-0x0019a000

stack = 0x00198000-0x0019a000

init = 0x0019a000-0x004d9000

available = 0x004d9000-0x037ff000

DMA Zone = 0x03e00000-0x04000000

Hardware Trace Active and Enabled

Reset caused by Software reset

Compiled for ADSP-BF537 Rev 0.2

Blackfin Linux support by blackfin.uclinux.org/

Processor Speed: 500 MHz core clock and 100 MHz System Clock

NOMPU: setting up cplb tables for global access

Instruction Cache Enabled for CPU0

Data Cache Enabled for CPU0 (write-through)

Built 1 zonelists in Zone order, mobility grouping off. Total pages: 14223

Kernel command line: root=/dev/mtdblock0 rw earlyprintk=serial,uart0,57600 console=ttyBF0,57600 ip=f

Configuring Blackfin Priority Driven Interrupts

PID hash table entries: 256 (order: 8, 1024 bytes)

console handover: boot [early_BFuart0] -> real [ttyBF0]

Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)

Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)

Memory available: 51796k/65536k RAM, (3324k init code, 1158k kernel code, 478k data, 2048k dma, 673)

Calibrating delay loop... 997.37 BogoMIPS (lpj=1994752)

Security Framework initialized

Mount-cache hash table entries: 512

Blackfin Scratchpad data SRAM: 4 KB

Blackfin L1 Data A SRAM: 16 KB (15 KB free)

Blackfin L1 Data B SRAM: 16 KB (16 KB free)

Blackfin L1 Instruction SRAM: 48 KB (41 KB free)

PDA for CPU0 reserved at 0017a4e0

net_namespace: 288 bytes

NET: Registered protocol family 16

Blackfin GPIO Controller

Blackfin DMA Controller

stamp_init(): registering device resources

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 2048 (order: 2, 16384 bytes)

TCP bind hash table entries: 2048 (order: 1, 8192 bytes)

TCP: Hash tables configured (established 2048 bind 2048)

TCP reno registered

NET: Registered protocol family 1

msgmni has been set to 101

io scheduler noop registered

io scheduler anticipatory registered (default)

io scheduler cfq registered

Serial: Blackfin serial driver

bfin-uart.1: ttyBF0 at MMIO 0xffc00400 (irq = 18) is a BFIN-UART

brd: module loaded

bfin_mac_mdio: probed

bfin_mac: attached PHY driver [SMSC LAN83C185] (mii_bus:phy_addr=0:01, irq=-1, mdc_clk=2500000Hz(md)

bfin_mac bfin_mac.0: Blackfin on-chip Ethernet MAC driver, Version 1.1

rtc-bfin rtc-bfin: rtc core: registered rtc-bfin as rtc0

bfin-wdt: initialized: timeout=20 sec (nowayout=0)

Advanced Linux Sound Architecture Driver Version 1.0.12rc1 (Thu Jun 22 13:55:50 2006 UTC).

dma_alloc_init: dma_page @ 0x032c1000 - 512 pages at 0x03e00000

ALSA device list:

#0: Analog Devices AD73322 at PF10 SPORT0 rx/tx dma 3/4 err irq 45

#1: Analog Devices AD73322 at PF14 SPORT1 rx/tx dma 5/6 err irq 46

TCP cubic registered

NET: Registered protocol family 17

rtc-bfin rtc-bfin: setting system clock to 2004-05-31 08:30:03 UTC (1085992203)

IP-Config: Complete:

device=eth0, addr=10.100.4.50, mask=255.255.255.0, gw=10.100.4.174,

host=bf537-stamp, domain=, nis-domain=(none),

bootserver=10.100.4.174, rootserver=10.100.4.174, rootpath=

Freeing unused kernel memory: 3324k freed

_____________________________________

a8888b. / Welcome to the uClinux distribution \

d888888b. / _ _ \

8P"YP"Y88 / | | |_| __ __ (TM) |

8|o||o|88 _____/ | | _ ____ _ _ \ \/ / |

8' .88 \ | | | | _ \| | | | \ / |

8`._.' Y8. \ | |__ | | | | | |_| | / \ |

d/ `8b. \ \____||_|_| |_|\____|/_/\_\ |

dP . Y8b. \ For embedded processors including |

d8:' " `::88b \ the Analog Devices Blackfin /

d8" 'Y88b \___________________________________/

:8P ' :888

8a. : _a88P For further information, check out:

._/"Yaa_: .| 88P| - blackfin.uclinux.org/

\ YP" `| 8P `. - docs.blackfin.uclinux.org/

/ \.___.d| .' - www.uclinux.org/

`--..__)8888P`._.' jgs/a:f - www.analog.com/blackfin

Have a lot of fun...

BusyBox v1.13.1 (2008-12-10 18:11:54 CST) built-in shell (msh)

Enter 'help' for a list of built-in commands.

root:/>

root:/> arecord -D plughw:0,0 -d 5 |aplay -D plughw:0,1

Recording WAVE 'stdin' : Unsigned 8 bit, Rate 8000 Hz, Mono

ALSA lib ../../../alsa-lib-1.0.12/src/pcm/pcm_plug.c:773:(snd_pcm_plug_hw_refine_schange) Unable to'

arecord: set_params:904: Sample format non available

aplay: playback:2021: read error

root:/>

root:/> arecord|aplay

Recording WAVE 'stdin' : Unsigned 8 bit, Rate 8000 Hz, Mono

Playing WAVE 'stdin' : Unsigned 8 bit, Rate 8000 Hz, Mono

^CAborted by signal Interrupt...

Aborted by signal Interrupt...

Follow-ups

--- Cliff Cai 2008-12-11 03:08:56

You need to copy a config file to /etc/asound on board.

see:https://blackfin.uclinux.org/gf/project/uclinux-dist/tracker/?action=TrackerItemEdit&tracker_id=328&tracker_item_id=4038

Cliff

--- Vivi Li 2008-12-15 04:00:01

This bug is not reproducible now. So close it.

Thanks!

Files

Changes

Commits

Dependencies

Duplicates

Associations

Partner Forums

Partner Libraries

[#4712] It fails to record and play at the same time for ad73322