[#5484] adv7183 test failed in trunk on bf561-ezkit
Submitted By: Vivi Li
Open Date
2009-09-02 22:28:20 Close Date
2009-10-13 03:57:37
Priority:
Medium Assignee:
Michael Hennerich
Status:
Closed Fixed In Release:
N/A
Found In Release:
2010R1 Release:
Category:
N/A Board:
N/A
Processor:
BF561 Silicon Revision:
Is this bug repeatable?:
Yes Resolution:
Fixed
Uboot version or rev.:
Toolchain version or rev.:
gcc4.1-09r1-rc9
App binary format:
N/A
Summary: adv7183 test failed in trunk on bf561-ezkit
Details:
adv7183 test failed in trunk on bf561-ezkit.
Bellow is the log and kernel config file is attached:
--
Linux version 2.6.30.5-ADI-2010R1-pre-svn7256 (test@uclinux66-561ezkit) (gcc version 4.1.2 (ADI svn)) #4 Wed Sep 2 10:30:20 CST 9
bootconsole [early_shadow0] enabled
bootconsole [early_BFuart0] enabled
early printk enabled on early_BFuart0
Board Memory: 64MB
Kernel Managed Memory: 64MB
Memory map:
fixedcode = 0x00000400-0x00000490
text = 0x00100000-0x00207340
rodata = 0x00207340-0x002638d8
bss = 0x00264000-0x002751e4
data = 0x002751e4-0x00288000
stack = 0x00286000-0x00288000
init = 0x00288000-0x00b30000
available = 0x00b30000-0x03dff000
DMA Zone = 0x03e00000-0x04000000
Hardware Trace Active and Enabled
Boot Mode: 0
Reset caused by Software reset
Blackfin support (C) 2004-2009 Analog Devices, Inc.
Compiled for ADSP-BF561 Rev 0.5
Blackfin Linux support by http://blackfin.uclinux.org/
Processor Speed: 600 MHz core clock and 100 MHz System Clock
NOMPU: setting up cplb tables
Instruction Cache Enabled for CPU0
External memory: cacheable in instruction cache
L2 SRAM : uncacheable in instruction cache
Data Cache Enabled for CPU0
External memory: cacheable (write-back) in data cache
L2 SRAM : uncacheable in data cache
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 15747
Kernel command line: root=/dev/mtdblock0 rw clkin_hz=30000000 earlyprintk=serial,uart0,57600 console=ttyBF0,57600 ip=10.100.4.50f
NR_IRQS:121
Configuring Blackfin Priority Driven Interrupts
PID hash table entries: 256 (order: 8, 1024 bytes)
console [ttyBF0] enabled, bootconsole disabled
console [ttyBF0] enabled, bootconsole disabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory available: 51460k/65536k RAM, (8864k init code, 1052k kernel code, 516k data, 2048k dma, 1592k reserved)
Calibrating delay loop... 1196.03 BogoMIPS (lpj=2392064)
Security Framework initialized
Mount-cache hash table entries: 512
Blackfin Scratchpad data SRAM: 4 KB
Blackfin L1 Data A SRAM: 16 KB (16 KB free)
Blackfin L1 Data B SRAM: 16 KB (16 KB free)
Blackfin L1 Instruction SRAM: 16 KB (5 KB free)
Blackfin L2 SRAM: 128 KB (128 KB free)
net_namespace: 296 bytes
NET: Registered protocol family 16
Blackfin DMA Controller
ezkit_init(): registering device resources
bio: create slab <bio-0> at 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
msgmni has been set to 100
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler cfq registered
Serial: Blackfin serial driver
bfin-uart.1: ttyBF0 at MMIO 0xffc00400 (irq = 35) is a BFIN-UART
brd: module loaded
smc91x.c: v1.1, sep 22 2004 by Nicolas Pitre <nico@cam.org>
eth0: SMC91C11xFD (rev 1) at 2c010300 IRQ 82 [nowait]
eth0: Ethernet addr: 00:e0:22:fe:b1:3c
bfin-spi bfin-spi.0: Blackfin on-chip SPI Controller Driver, Version 1.0, regs_base@ffc00500, dma channel@16
i2c-gpio i2c-gpio.0: using pins 1 (SDA) and 0 (SCL)
Linux video capture interface: v2.00
driver for ADV7183B get_camops
driver for ADV7183B get_camops
ADV7183B: detecting client on address 0x40
driver for ADV7183B init
ADV7183B: V4L driver Blackfin CMOS Camera now ready
ADV7183B: i2c driver ready
bfin-wdt: initialized: timeout=20 sec (nowayout=0)
TCP cubic registered
NET: Registered protocol family 17
eth0: link down
IP-Config: Complete:
device=eth0, addr=10.100.4.50, mask=255.255.255.0, gw=10.100.4.174,
host=bf561-ezkit, domain=, nis-domain=(none),
bootserver=10.100.4.174, rootserver=10.100.4.174, rootpath=
Freeing unused kernel memory: 8864k freed
dma_alloc_init: dma_page @ 0x00bf7000 - 512 pages at 0x03e00000
_____________________________________
a8888b. / Welcome to the uClinux distribution \
d888888b. / _ _ \
8P"YP"Y88 / | | |_| __ __ (TM) |
8|o||o|88 _____/ | | _ ____ _ _ \ \/ / |
8' .88 \ | | | | _ \| | | | \ / |
8`._.' Y8. \ | |__ | | | | | |_| | / \ |
d/ `8b. \ \____||_|_| |_|\____|/_/\_\ |
dP . Y8b. \ For embedded processors including |
d8:' " `::88b \ the Analog Devices Blackfin /
d8" 'Y88b \___________________________________/
:8P ' :888
8a. : _a88P For further information, check out:
._/"Yaa_: .| 88P| - http://blackfin.uclinux.org/
\ YP" `| 8P `. - http://docs.blackfin.uclinux.org/
/ \.___.d| .' - http://www.uclinux.org/
`--..__)8888P`._.' jgs/a:f - https://www.analog.com/blackfin
Have a lot of fun...
BusyBox v1.15.0 (2009-09-02 10:26:32 CST) hush - the humble shell
e
tooh:/0 : link up, 100Mbps, full-duplex, lpa 0x41E1
root:/>
root:/> ffmpeg -f video4linux -r 10.0 -s 720x288 -i /dev/video0 -qscale 6 -f mjpeg udp:10.100.4.174:1234
FFmpeg version SVN-r8802, Copyright (c) 2000-2007 Fabrice Bellard, et al.
configuration: --prefix=/usr --source-path=/home/test/work/cruise/checkouts/uclinux-dist/lib/ffmpeg/build/../ffmpeg-svn-11114 -
libavutil version: 49.5.0
libavcodec version: 51.48.0
libavformat version: 52.1.0
built on Sep 2 2009 10:25:23, gcc: 4.1.2 (ADI svn)
[video4linux @ 0x381078]VIDIOCGCAP: Invalid argument
/dev/video0: I/O error occured
Usually that means that input file is truncated and/or corrupted.
root:/>
root:/> version
kernel: Linux release 2.6.30.5-ADI-2010R1-pre-svn7256, build #4 Wed Sep 2 10:30:20 CST 2009
toolchain: bfin-linux-uclibc-gcc release gcc version 4.1.2 (ADI svn)
user-dist: release svn-8802, build #50 Wed Sep 2 10:29:17 CST 2009
root:/>
--
Follow-ups
--- Michael Hennerich 2009-09-03 03:58:28
assign to me
-Michael
--- Michael Hennerich 2009-09-30 10:50:53
v4l_ioctl parameter list changed
fixed on trunk.
-Michael
--- Vivi Li 2009-10-13 03:57:37
OK now on bf561-ezkit.
Close it.
Files
Changes
Commits
Dependencies
Duplicates
Associations
Tags
File Name File Type File Size Posted By
config.camera_adv7183 application/octet-stream 31228 Vivi Li