[#6875] Netaudio fails to mount samba server in 2010r1 branch.
Submitted By: Vivi Li
Open Date
2011-11-10 05:13:15
Priority:
Medium Assignee:
Vivi Li
Aaron Wu
Status:
Open Fixed In Release:
N/A
Found In Release:
2011R1 Release:
Category:
N/A Board:
N/A
Processor:
ALL Silicon Revision:
Is this bug repeatable?:
Yes Resolution:
Assigned (Not Start)
Uboot version or rev.:
Toolchain version or rev.:
gcc4.3-2011R1-RC2
App binary format:
N/A
Summary: Netaudio fails to mount samba server in 2010r1 branch.
Details:
Netaudio fails to mount samba server in 2010r1 branch.
I think we need to use cifs mount instead of smbmount.
Build script also needs upgrade.
--
U-Boot 2010.06-svn2487 (ADI-2010R1) (Oct 27 2010 - 04:28:50)
CPU: ADSP bf537-0.2 (Detected Rev: 0.2) (bypass boot)
Board: ADI BF537 stamp board
Support: http://blackfin.uclinux.org/
Clock: VCO: 500 MHz, Core: 500 MHz, System: 125 MHz
RAM: 64 MiB
Flash: 4 MiB
In: serial
Out: serial
Err: serial
KGDB: [on serial] ready
Net: bfin_mac
Hit any key to stop autoboot: 0
Using bfin_mac device
TFTP from server 10.100.4.174; our IP address is 10.100.4.50
Filename 'uImage'.
Load address: 0x1000000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#############################
done
Bytes transferred = 5192383 (4f3abf hex)
## Booting kernel from Legacy Image at 01000000 ...
Image Name: bf537-0.2-3.0.8-ADI-2011R1-svn10
Created: 2011-11-10 3:15:03 UTC
Image Type: Blackfin Linux Kernel Image (gzip compressed)
Data Size: 5192319 Bytes = 5 MiB
Load Address: 00001000
Entry Point: 001dfc48
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting Kernel at = 001dfc48
Linux version 3.0.8-ADI-2011R1-svn10145 (test@uclinux50-bf537-9960-1836) (gcc version 4.3.5 (ADI-2011R1-RC2) ) #66 Thu Nov 10 111
register early platform devices
bootconsole [early_shadow0] enabled
bootconsole [early_BFuart0] enabled
early printk enabled on early_BFuart0
Limiting kernel memory to 56MB due to anomaly 05000263
Board Memory: 64MB
Kernel Managed Memory: 64MB
Memory map:
fixedcode = 0x00000400-0x00000490
text = 0x00001000-0x00149d78
rodata = 0x00149d78-0x001b3db4
bss = 0x001b4000-0x001c432c
data = 0x001c432c-0x001d8000
stack = 0x001d6000-0x001d8000
init = 0x001d8000-0x0096f000
available = 0x0096f000-0x03800000
DMA Zone = 0x03e00000-0x04000000
Hardware Trace active and enabled
Boot Mode: 0
Blackfin support (C) 2004-2010 Analog Devices, Inc.
Compiled for ADSP-BF537 Rev 0.2
Blackfin Linux support by http://blackfin.uclinux.org/
Processor Speed: 500 MHz core clock and 125 MHz System Clock
NOMPU: setting up cplb tables
Instruction Cache Enabled for CPU0
External memory: cacheable in instruction cache
Data Cache Enabled for CPU0
External memory: cacheable (write-back) in data cache
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 14224
Kernel command line: root=/dev/mtdblock0 rw clkin_hz=25000000 earlyprintk=serial,uart0,57600 console=ttyBF0,57600 ip=10.100.4.50f
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory available: 47076k/65536k RAM, (7772k init code, 1315k kernel code, 569k data, 2048k dma, 6756k reserved)
NR_IRQS:146
Configuring Blackfin Priority Driven Interrupts
console [ttyBF0] enabled, bootconsole disabled
console [ttyBF0] enabled, bootconsole disabled
Calibrating delay loop... 995.32 BogoMIPS (lpj=1990656)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
Blackfin Scratchpad data SRAM: 4 KB
Blackfin L1 Data A SRAM: 16 KB (16 KB free)
Blackfin L1 Data B SRAM: 16 KB (16 KB free)
Blackfin L1 Instruction SRAM: 48 KB (35 KB free)
NET: Registered protocol family 16
Blackfin DMA Controller
stamp_init(): registering device resources
bio: create slab <bio-0> at 0
bfin-spi bfin-spi.0: Blackfin on-chip SPI Controller Driver, Version 1.0, regs@ffc00500, dma channel@7
Advanced Linux Sound Architecture Driver Version 1.0.24.
Switching to clocksource bfin_cs_cycles
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
debug-mmrs: setting up Blackfin MMR debugfs
msgmni has been set to 91
io scheduler noop registered (default)
bfin-uart: Blackfin serial driver
bfin-uart.0: ttyBF0 at MMIO 0xffc00400 (irq = 18) is a BFIN-UART
brd: module loaded
bfin_mii_bus: probed
bfin_mac: attached PHY driver [SMSC LAN83C185] (mii_bus:phy_addr=0:01, irq=-1, mdc_clk=2500000Hz(mdc_div=24)@sclk=125MHz)
bfin_mac bfin_mac.0: eth0: Blackfin on-chip Ethernet MAC driver, Version 1.1
rtc-bfin rtc-bfin: rtc core: registered rtc-bfin as rtc0
bfin-wdt: initialized: timeout=20 sec (nowayout=0)
bfin-tdm bfin-tdm.0: dma rx:3 tx:4, err irq:45, regs:ffc00800
dma_alloc_init: dma_page @ 0x029d3000 - 512 pages at 0x03e00000
asoc: ad1836-hifi <-> bfin-tdm.0 mapping ok
ALSA device list:
#0: bfin-ad1836
TCP cubic registered
NET: Registered protocol family 17
rtc-bfin rtc-bfin: setting system clock to 1970-01-03 01:27:46 UTC (178066)
IP-Config: Complete:
device=eth0, addr=10.100.4.50, mask=255.255.255.0, gw=10.100.4.174,
host=bf537-stamp, domain=, nis-domain=(none),
bootserver=10.100.4.174, rootserver=10.100.4.174, rootpath=
Freeing unused kernel memory: 7772k freed
_____________________________________
a8888b. / Welcome to the uClinux distribution \
d888888b. / _ _ \
8P"YP"Y88 / | | |_| __ __ (TM) |
8|o||o|88 _____/ | | _ ____ _ _ \ \/ / |
8' .88 \ | | | | _ \| | | | \ / |
8`._.' Y8. \ | |__ | | | | | |_| | / \ |
d/ `8b. \ \____||_|_| |_|\____|/_/\_\ |
dP . Y8b. \ For embedded processors including |
d8:' " `::88b \ the Analog Devices Blackfin /
d8" 'Y88b \___________________________________/
:8P ' :888
8a. : _a88P For further information, check out:
._/"Yaa_: .| 88P| - http://blackfin.uclinux.org/
\ YP" `| 8P `. - http://docs.blackfin.uclinux.org/
/ \.___.d| .' - http://www.uclinux.org/
`--..__)8888P`._.' jgs/a:f - https://www.analog.com/blackfin
Have a lot of fun...
BusyBox v1.18.4 (2011-11-10 11:11:01 CST) hush - the humble shell
root:/> PHY: 0:01 - Link is Up - 100/Full
root:/> PHY: 0:01 - Link is Down
root:/> dPHY: 0:01 - Link is Up - 100/Full
root:/> dhcpcd &
[1] 198 dhcpcd
root:/>
root:/> ifconfig
eth0 Link encap:Ethernet HWaddr 00:E0:22:FE:42:93
inet addr:10.99.22.89 Bcast:10.99.22.255 Mask:255.255.255.0
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:258 errors:0 dropped:6 overruns:0 frame:0
TX packets:9 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:36317 (35.4 KiB) TX bytes:2919 (2.8 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
root:/>
root:/> cat /etc/config/smb.conf
[global]
workgroup = WORKGROUP
encrypt passwords = yes
root:/>
root:/> boa -c /etc &
[2] 204 boa -c /etc
root:/> [03/Jan/1970:01:30:20 +0000] boa: server version Boa/0.94.14rc21
[03/Jan/1970:01:30:20 +0000] boa: server built Nov 10 2011 at 11:10:58.
[03/Jan/1970:01:30:20 +0000] boa: starting server pid=205, port 80
10.99.24.89 - - [03/Jan/1970:01:31:33 +0000] request "GET /favicon.ico HTTP/1.1" ("/home/httpd/www/html/favicon.ico"): document y
10.99.24.89 - - [03/Jan/1970:01:31:33 +0000] request "GET /favicon.ico HTTP/1.1" ("/home/httpd/www/html/favicon.ico"): document y
Mounting the Remote shared directory : //10.99.22.69/music
sh: can't execute 'smbmount': No such file or directory
--
Follow-ups
No Messages Were Found
Files
Changes
Commits
Dependencies
Duplicates
Associations
Tags
File Name File Type File Size Posted By
config.config.netaudio application/octet-stream 52024 Vivi Li
config.linux.netaudio application/octet-stream 36252 Vivi Li