[#6952] mount spi flash on bf526 ezbrd fail on trunk head(2012)

[#6952] mount spi flash on bf526 ezbrd fail on trunk head

Submitted By: Mingquan Pan

Open Date

2012-01-12 03:23:26 Close Date

2012-01-17 05:00:08

Priority:

Medium Assignee:

Scott Jiang

Status:

Closed Fixed In Release:

N/A

Found In Release:

N/A Release:

Category:

N/A Board:

N/A

Processor:

BF526 Silicon Revision:

Is this bug repeatable?:

Yes Resolution:

Assigned (Not Start)

Uboot version or rev.:

Toolchain version or rev.:

2011r1-rc4

App binary format:

N/A

Summary: mount spi flash on bf526 ezbrd fail on trunk head

Details:

mount spi flash on bf526 ezbrd fail on trunk head.

## Booting kernel from Legacy Image at 02000000 ...

Image Name: bf526-0.0-3.1.0-ADI-2012R1-pre-s

Created: 2012-01-10 8:31:08 UTC

Image Type: Blackfin Linux Kernel Image (gzip compressed)

Data Size: 2142309 Bytes = 2 MiB

Load Address: 00001000

Entry Point: 001ccca8

Verifying Checksum ... OK

Uncompressing Kernel Image ... OK

Starting Kernel at = 001ccca8

Linux version 3.1.0-ADI-2012R1-pre-svn10275 (test@uclinux81-bf526) (gcc version 4.3.5 (ADI-2011R1-RC4) ) #54 Tue Jan 10 16:31:00 CST 2012

bootconsole [early_shadow0] enabled

bootconsole [early_BFuart1] enabled

early printk enabled on early_BFuart1

Board Memory: 64MB

Kernel Managed Memory: 64MB

Memory map:

fixedcode = 0x00000400-0x00000490

text = 0x00001000-0x0013c778

rodata = 0x0013c778-0x001a0c28

bss = 0x001a1000-0x001b1510

data = 0x001b1510-0x001c4000

stack = 0x001c2000-0x001c4000

init = 0x001c4000-0x003bd000

available = 0x003bd000-0x03f00000

DMA Zone = 0x03f00000-0x04000000

Hardware Trace active and enabled

Boot Mode: 1

Compiled for ADSP-BF526 Rev 0.0

Blackfin Linux support by http://blackfin.uclinux.org/

Processor Speed: 400 MHz core clock and 80 MHz System Clock

NOMPU: setting up cplb tables

Instruction Cache Enabled for CPU0

External memory: cacheable in instruction cache

Data Cache Enabled for CPU0

External memory: cacheable (write-back) in data cache

Built 1 zonelists in Zone order, mobility grouping off. Total pages: 16002

Kernel command line: root=/dev/mtdblock0 rw ip=10.100.4.50 earlyprintk=serial,uart1,57600 console=ttyBF1,57600 ip=10.100.4.50:10.100.4.174:10.100.4.174:255.255.255.0:bf526-ezbrd:eth0:off

PID hash table entries: 256 (order: -2, 1024 bytes)

Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)

Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)

Memory available: 60076k/65536k RAM, (2020k init code, 1261k kernel code, 543k data, 1024k dma, 612k reserved)

NR_IRQS:159

Configuring Blackfin Priority Driven Interrupts

console [ttyBF1] enabled, bootconsole disabled

Calibrating delay loop... 792.57 BogoMIPS (lpj=1585152)

pid_max: default: 32768 minimum: 301

Mount-cache hash table entries: 512

Blackfin Scratchpad data SRAM: 4 KB

Blackfin L1 Data A SRAM: 16 KB (16 KB free)

Blackfin L1 Data B SRAM: 16 KB (16 KB free)

Blackfin L1 Instruction SRAM: 48 KB (41 KB free)

NET: Registered protocol family 16

Blackfin DMA Controller

ezbrd_init(): registering device resources

bio: create slab <bio-0> at 0

bfin-spi bfin-spi.0: Blackfin on-chip SPI Controller Driver, Version 1.0, regs@ffc00500, dma channel@7

i2c-bfin-twi i2c-bfin-twi.0: Blackfin BF5xx on-chip I2C TWI Contoller, regs_base@ffc01400

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 2048 (order: 2, 16384 bytes)

TCP bind hash table entries: 2048 (order: 1, 8192 bytes)

TCP: Hash tables configured (established 2048 bind 2048)

TCP reno registered

UDP hash table entries: 256 (order: 0, 4096 bytes)

UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)

NET: Registered protocol family 1

debug-mmrs: setting up Blackfin MMR debugfs

JFFS2 version 2.2. (NAND) 2001-2006 Red Hat, Inc.

msgmni has been set to 117

io scheduler noop registered (default)

bfin-uart: Blackfin serial driver

bfin-uart.1: ttyBF1 at MMIO 0xffc02000 (irq = 31) is a BFIN-UART

bfin-otp: initialized

brd: module loaded

physmap platform flash device: 00400000 at 20000000

physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x000020 Chip ID 0x008815

Intel/Sharp Extended Query Table at 0x0039

cfi_cmdset_0001: Erase suspend on write enabled

Using physmap partition information

Creating 3 MTD partitions on "physmap-flash.0":

0x000000000000-0x000000040000 : "bootloader(nor)"

0x000000040000-0x000000200000 : "linux kernel(nor)"

0x000000200000-0x000000400000 : "file system(nor)"

m25p80 spi0.1: sst25wf040 (512 Kbytes)

Creating 2 MTD partitions on "m25p80":

0x000000000000-0x000000040000 : "bootloader(spi)"

0x000000040000-0x000000080000 : "linux kernel(spi)"

bfin_mii_bus: probed

bfin_mac: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:01, irq=-1, mdc_clk=2500000Hz(mdc_div=15)@sclk=80MHz)

bfin_mac bfin_mac.0: eth0: Blackfin on-chip Ethernet MAC driver, Version 1.1

TCP cubic registered

NET: Registered protocol family 17

dma_alloc_init: dma_page @ 0x023da000 - 256 pages at 0x03f00000

IP-Config: Complete:

device=eth0, addr=10.100.4.50, mask=255.255.255.0, gw=10.100.4.174,

host=bf526-ezbrd, domain=, nis-domain=(none),

...

BusyBox v1.18.4 (2012-01-09 23:57:38 CST) hush - the humble shell

root:/> versiPHY: 0:01 - Link is Up - 100/Full

kernel: Linux release 3.1.0-ADI-2012R1-pre-svn10275, build #54 Tue Jan 10 16:31:00 CST 2012

toolchain: bfin-uclinux-gcc release gcc version 4.3.5 (ADI-2011R1-RC4)

user-dist: release svn-10617, build #637 Tue Jan 10 16:30:09 CST 2012

root:/> successful boot attempt

************** STEP 3: MTD test

cat /proc/mtd

dev: size erasesize name

mtd0: 00040000 00010000 "bootloader(nor)"

mtd1: 001c0000 00010000 "linux kernel(nor)"

mtd2: 00200000 00010000 "file system(nor)"

mtd3: 00040000 00001000 "bootloader(spi)"

mtd4: 00040000 00001000 "linux kernel(spi)"

root:/>

Case 1 ...PASS

************** STEP 4: Mount MTD

mount -t jffs2 /dev/mtdblock4 /mnt

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000000: 0xe10e instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000004: 0xe14e instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000008: 0xe10d instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0000000c: 0xe14d instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000010: 0x6190 instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000014: 0x6001 instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000018: 0x3629 instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0000001c: 0x3639 instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000020: 0x3c19 instead

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000024: 0xe300 instead

Further such events for this erase block will not be printed

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00001000: 0x9709 instead

...Further such events for this erase block will not be printed^M

Empty flash at 0x00033508 ends at 0x0003350c^M

Empty flash at 0x00033918 ends at 0x0003391c^M

Empty flash at 0x00033924 ends at 0x00033928^M

Empty flash at 0x00033980 ends at 0x00033988^M

Empty flash at 0x0003398c ends at 0x00033994^M

Empty flash at 0x00033998 ends at 0x0003399c^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00034000: 0x9178 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00034008: 0x92e4 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003400c: 0x0002 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00034014: 0x8ad8 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00034018: 0x92ec instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003401c: 0x9308 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00034020: 0xa7a0 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00034024: 0x9334 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00034028: 0x0010 instead^M

jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003402c: 0x0001 instead^M

Further such events for this erase block will not be printed^M

Cowardly refusing to erase blocks on filesystem with no valid JFFS2 nodes^M

empty_blocks 11, bad_blocks 0, c->nr_blocks 64^M

mount: mounting /dev/mtdblock4 on /mnt failed

Last passed time: 2011_Dec_11_16_22.

Uclinux-dist version: 10570.

Kernel verion: 10259, git-id: de8f67b314312a4bc9e5003ecde6c28a6be607bc

Case 2 ...FAIL

Follow-ups

--- Mingquan Pan 2012-01-17 05:28:51

The flash chip restore back to ok after doing flash erase on it. So close.

Files

Changes

Commits

Dependencies

Duplicates

Associations