[#3905] Can't found eth0 device on EZKIT-548 with svn trunk kernel
Submitted By: Bryan Wu
Open Date
2008-02-18 03:49:40 Close Date
2008-02-21 01:55:15
Priority:
Medium Assignee:
Bryan Wu
Status:
Closed Fixed In Release:
N/A
Found In Release:
N/A Release:
Category:
N/A Board:
EZKIT Lite
Processor:
BF548 Silicon Revision:
Is this bug repeatable?:
Yes Resolution:
Fixed
Uboot version or rev.:
Toolchain version or rev.:
App binary format:
N/A
Summary: Can't found eth0 device on EZKIT-548 with svn trunk kernel
Details:
--
Linux version 2.6.24.2-ADI-2008R2-pre-svn4288 (roc@roc-desktop) (gcc version 4.1.2 (ADI svn)) #29 Mon Feb 18 16:34:02 CST 2008
console [early_BFuart0] enabled
early printk enabled on early_BFuart0
Board Memory: 64MB
Kernel Managed Memory: 64MB
Memory map:
fixedcode = 0x00000400-0x00000490
text = 0x00001000-0x001921b0
rodata = 0x001922e0-0x00213b3c
bss = 0x00213b40-0x00227224
data = 0x00227224-0x00244000
stack = 0x00242000-0x00244000
init = 0x00244000-0x006ba000
available = 0x006ba000-0x03dff000
DMA Zone = 0x03e00000-0x04000000
Hardware Trace Active and Enabled
Blackfin support (C) 2004-2008 Analog Devices, Inc.
Compiled for ADSP-BF548 Rev 0.0
Warning: Compiled for Rev 0, but running on Rev 1
Blackfin Linux support by blackfin.uclinux.org/
Processor Speed: 525 MHz core clock and 131 MHz System Clock
Instruction Cache Enabled
Data Cache Enabled (write-through)
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 15748
Kernel command line: root=/dev/mtdblock0 rw earlyprintk=serial,uart1,57600 console=ttyBF0,57600 ip=192.168.0.66:192.168.0.55:192.168.0.1:2f
Configuring Blackfin Priority Driven Interrupts
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x25
console handover: boot [early_BFuart0] -> real [ttyBF0]
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory available: 56012k/65536k RAM, (4568k init code, 1604k kernel code, 712k data, 2048k dma, 588k reserved)
Blackfin Scratchpad data SRAM: 4 KB
Blackfin Data A SRAM: 16 KB (15 KB free)
Blackfin Data B SRAM: 16 KB (16 KB free)
Blackfin Instruction SRAM: 48 KB (42 KB free)
Security Framework initialized
Mount-cache hash table entries: 512
net_namespace: 64 bytes
NET: Registered protocol family 16
Blackfin GPIO Controller
Blackfin DMA Controller
ezkit_init(): registering device resources
SCSI subsystem initialized
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler cfq registered
bf54x-lq043: FrameBuffer initializing...
dma_alloc_init: dma_page @ 0x0342b000 - 512 pages at 0x03e00000
Console: switching to colour frame buffer device 80x24
bfin-otp: initialized
Serial: Blackfin serial driver
bfin-uart.1: ttyBF0 at MMIO 0xffc02000 (irq = 48) is a BFIN-UART
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
smsc911x: Driver version 2007-07-13.
Driver 'sd' needs updating - please use bus_type methods
Driver 'sr' needs updating - please use bus_type methods
register bfin atapi driver
scsi0 : pata-bf54x
ata1: PATA max UDMA/66 irq 68
ata1.00: ATA-6: TOSHIBA MK4032GAX, AD101A, max UDMA/100
ata1.00: 78140160 sectors, multi 16: LBA48
ata1.00: configured for UDMA/66
blk_queue_max_hw_segments: set to minimum 1
scsi 0:0:0:0: Direct-Access ATA TOSHIBA MK4032GA AD10 PQ: 0 ANSI: 5
sd 0:0:0:0: [sda] 78140160 512-byte hardware sectors (40008 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sd 0:0:0:0: [sda] 78140160 512-byte hardware sectors (40008 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sda: sda1
sd 0:0:0:0: [sda] Attached SCSI disk
physmap platform flash device: 01000000 at 20000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
Intel/Sharp Extended Query Table at 0x010A
Unknown Intel/Sharp Extended Query version 1.5.
gen_probe: No supported Vendor Command Set found
physmap-flash physmap-flash.0: map_probe failed
BF5xx on-chip NAND FLash Controller Driver, Version 1.2 (c) 2007 Analog Devices, Inc.
bf5xx-nand bf5xx-nand.0: page_size=256, data_width=8, wr_dly=3, rd_dly=3
NAND device: Manufacturer ID: 0x20, Chip ID: 0xda (ST Micro NAND 256MiB 3,3V 8-bit)
Creating 2 MTD partitions on "NAND 256MiB 3,3V 8-bit":
0x00000000-0x00400000 : "Linux Kernel"
0x00400000-0x10000000 : "File System"
bfin-spi bfin-spi.0: Blackfin BF5xx on-chip SPI Controller Driver, Version 1.0, regs_base@ffc00500, dma channel@4
bfin-spi bfin-spi.1: Blackfin BF5xx on-chip SPI Controller Driver, Version 1.0, regs_base@ffc02300, dma channel@5
input: bf54x-keys as /class/input/input0
bf54x-keys: Blackfin BF54x Keypad registered IRQ 76
rtc-bfin rtc-bfin: rtc core: registered rtc-bfin as rtc0
i2c /dev entries driver
i2c-bfin-twi i2c-bfin-twi.1: Blackfin BF5xx on-chip I2C TWI Contoller Driver, Version 1.8, regs_base@ffc02200
bfin-wdt: initialized: timeout=20 sec (nowayout=0)
Advanced Linux Sound Architecture Driver Version 1.0.12rc1 (Thu Jun 22 13:55:50 2006 UTC).
ASoC version 0.13.1
AD1980 SoC Audio Codec
asoc: AC97 <-> bf5xx-ac97 mapping ok
ALSA device list:
#0: bf5xx-board (AD1980-MMAP)
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
rtc-bfin rtc-bfin: setting system clock to 1970-01-01 07:25:47 UTC (26747)
IP-Config: Failed to open eth0
IP-Config: Device `eth0' not found.
Freeing unused kernel memory: 4568k freed
_____________________________________
a8888b. / Welcome to the uClinux distribution \
d888888b. / _ _ \
8P"YP"Y88 / | | |_| __ __ (TM) |
8|o||o|88 _____/ | | _ ____ _ _ \ \/ / |
8' .88 \ | | | | _ \| | | | \ / |
8`._.' Y8. \ | |__ | | | | | |_| | / \ |
d/ `8b. \ \____||_|_| |_|\____|/_/\_\ |
dP . Y8b. \ For embedded processors including |
d8:' " `::88b \ the Analog Devices Blackfin /
d8" 'Y88b \___________________________________/
:8P ' :888
8a. : _a88P For further information, check out:
._/"Yaa_: .| 88P| - blackfin.uclinux.org/
\ YP" `| 8P `. - docs.blackfin.uclinux.org/
/ \.___.d| .' - www.uclinux.org/
`--..__)8888P`._.' jgs/a:f - www.analog.com/blackfin
Have a lot of fun...
BusyBox v1.9.1 (2008-02-18 12:18:40 CST) built-in shell (msh)
Enter 'help' for a list of built-in commands.
root:/> ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
root:/> ifconfig eth0 up
SIOCSIFFLAGS: Invalid argument
root:/>
---
Follow-ups
--- Bryan Wu 2008-02-18 04:43:31
it is fixed in svn kernel trunk.
-Bryan
--- Bryan Wu 2008-02-21 01:55:14
close it.
Files
Changes
Commits
Dependencies
Duplicates
Associations
Tags
File Name File Type File Size Posted By
No Files Were Found