ADSP-BF548 EZ-KIT LITE USB INTERFACE

Tanu on May 8, 2013

In the reference manual of ADSP-BF548 EZ-KIT LITE , I have certain queries in the circuit of USB.

Please refer to Pg 120 of the attached manual.In this it has been mentioned that Pins 1&3 and pins 2&4 of jumper JP11 should always be populated. May I know what is the purpose of this jumper.

By using this jumper , we are supplying power to USB module of DSP , which can directly be given using 3.3V , then what is the need of generating 3.6V

ADSP-BF548_ezkit_man_rev.1.4.pdf

Parents

0 ADIApproved

on May 10, 2013 1:09 PM
Hi Tanu,

As this question is specifically about the EZ-KIT Lite, I have moved it from the Blackfin Processors community to the Hardware Tools community. I will ask someone from the Hardware Team to take a look.

Regards,

Craig.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Reply

0 ADIApproved

on May 10, 2013 1:09 PM
Hi Tanu,

As this question is specifically about the EZ-KIT Lite, I have moved it from the Blackfin Processors community to the Hardware Tools community. I will ask someone from the Hardware Team to take a look.

Regards,

Craig.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel

Children

No Data