My question concerns the schematic of the evalboard and therefore a special part on sheet 4.
on this page there is a voltage divide connected to GND pin C3(GND63) which is also connected to a voltage divider and a testpoint TP3
whats the purpose of this part ? only for testing?
And also GND62(B2) is connected via 0Ohm resistor to ground.
For our new design it is ok to connect this to pins directly to gnd . or whats the background of this schematic???
kind regards chris
Moving discussion to Hardware Tools forum for discussion.
On customer designs, ball B2 and C3 should be tied directly to ground.