Hi,
We are using SC 594 SOM borad, in combination with Carrier and breakout boards. For the linkport we are trying with the loop back available in the examples folder. The loopback connections are as shown in the attached images ( 5 connections on the top and 5 on the bottom.)
While debugging we see that, though the code reaches to the point of adi_linkport_DMATransfer the linkports are not enabled through control register and also the dmas are not enabled in configuration register. The example shows it is for EZ Lite can it be used on the board shown in figure, if not could you please help us with the relevant ones.
Could you please help us in resolving the issue. Laslty, for some examples which work on EZ kit and EZ kit lite like SPI DMA mode, when we load the project we get SPIDMAMode_SC594_Cortex_Core0, SPIDMAMode_SC594_SHARC_Core0. What is the difference and we normally did not get this while creating new project.
What is the difference and we normally did not get this while creating new project.
[edited by: BVS at 3:54 AM (GMT -4) on 14 Mar 2025]