I have errors in using ICE-2000 for ADSP-BF531 developping.
I have attached error display file.
Your advice is helpful.
Hi,We recommend you to go though the debugging steps in the below linked FAQ which might helps you.ez.analog.com/.../faq-what-is-the-cause-of-a-core-fault-detected-before-halt-at-address-error-messageIf external memory had not been set up correctly, we can expect the "Warning: External memory is disabled for this region of memory" message.While working with an Ez-Kit there is an option "Use XML reset values" in 'settings -> Target option', which instructs the emulator to reference the XML file to configure some registers on the target when it is reset; this option is enabled by default.We understand that you are using ADSP-BF531 custom board. If so, you have to set up a Custom Board File and associate it with your session.For more information you can refer the following FAQ:FAQ: My application behaves incorrectly when using SDRAM.ez.analog.com/.../faq-my-application-behaves-incorrectly-when-using-sdramRegards,Santha kumari.K