Question:
How to connect "Do Not Disturb" CCES Tool without halting processor core.
Answer:
From CCES 2.12.0 version onwards it is possible to use "Do Not Disturb" mode in CCES as like VDSP.
The below steps needs to be followed
Step1> Be sure to uncheck 'Reset core before load' and check 'Load symbols only' for each core including preload file as shown below.
Step2> Under the Target Options tab in the debug configuration be sure to also uncheck 'Halt core after connecting to target' for each core as shown below.
NOTE: Halt core after connecting to target will be grayed out until Load symbols only is checked
Also below FAQ also will be helpful.
https://ez.analog.com/dsp/software-and-development-tools/hardware-tools/w/documents/6749/how-to-debug-a-target-board-which-boots-from-flash-using-crosscore-embedded-studio