ldr load

Question

Hi, 
 I am using the 21835-SOM development board.but when I running "Flash_Programmer_21835_EZKIT.bat",After a long time, I still cannot complete the download. 
 Please help me solve this problem. 
 Regards, 
 Bingo

Santhakumari · Accepted Answer

Hi Bingo, 
 Yes, setting BMODE to 0 is required for successfully flashing an LDR file onto the ADSP-SC835-SOM evaluation board using CLDP or the CCES GUI. For detailed guidance on flashing via the CCES GUI, refer to the "Booting an Application" section available in the CCES Help documentation at the following path: Help > CrossCore&reg; Embedded Studio 3.x.x > SHARC&reg;-FX Development Tools Documentation > Getting Started Guide > Getting Started Guide for CrossCore Embedded Studio with SHARC-FX support Note: Make sure your application does not perform any standard I/O functions, such as printf. These functions cannot be used without a debugger attached, and may cause your application to fail to run. 
 Hope this helps. 
 Best Regards, Santha kumari.V)

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Latest Webinars

Challenge Yourself!

What's Brewing

Places

Resources

Highlighted Blogs

Latest Blogs

ADI Blogs

Visit ContentZone

Featured Content

View Content By Industry

View Content By Technology

Products Mentioned

Thread Details

ldr load

Thread Summary

Thread Notes