[LINUX] How do I flash the program binary onto the SPI2 memory on ADSP-SC573 EZ-Board

analoggggez on May 26, 2022

Category: Software

I have a working binary of a program that I debug using OpenOCD and GDB. How do I go from here to deploying the program such that if I reset the SC573 ezkit in boot mode 1, it will run that program automatically?

Note that I am using Linux with CCES version 2.11.0

Top Replies

santha.vijay
May 27, 2022 +1 suggested
Hi,

We recommend to refer the below linked Wiki page, for more details on flashing in linux.
wiki.analog.com/.../installing_uboot

Regards,
Santhakumari.K
chadw
Jun 1, 2022 in reply to analoggggez +1 verified
Hello,

Unfortunately we only currently have support for this under Windows. We are working on supporting this using our CrossCore Serial Flash Programmer but it is not quite to the point of being ready…

0 santha.vijay

on May 27, 2022 2:51 PM
Hi,

We recommend to refer the below linked Wiki page, for more details on flashing in linux.
wiki.analog.com/.../installing_uboot

Regards,
Santhakumari.K
Cancel
Up +1 Down

Reply

Verify Answer

Reject Answer

Cancel
0 analoggggez on May 29, 2022 11:42 PM in reply to santha.vijay

Hi Santhakumari,

Thanks for the reply. I think there might be a miscommunication in my question.

The program binary we're trying to flash is a freeRTOS application, while my host development environment is in Linux, and we're using the Linux version of CCES.

We have found a process to flash program binary using windows host, but not Linux. Hence the question above.

Sorry for the confusion and I look forward to hearing from you.

Cheers
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 analoggggez on Jun 1, 2022 7:22 AM in reply to analoggggez

Hi santha.vijay , any updates on this?
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 santha.vijay

on Jun 1, 2022 9:15 AM in reply to analoggggez
Hi,

I am checking with our Internal team now. I will get back to you once I get a response from them.

Best Regards,
Santhakumari.K
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
+1 chadw

on Jun 1, 2022 9:02 PM in reply to analoggggez
Hello,

Unfortunately we only currently have support for this under Windows. We are working on supporting this using our CrossCore Serial Flash Programmer but it is not quite to the point of being ready.

Regards,

Chad
Cancel
Up +1 Down

Reply

Reject Answer

Cancel