ADAU1701 I2C read

Question

Hi 
 My customer is trying to initiate an i2c read from adau1701. 
 Addr0==Addr1=0 => Write addr = 0x68, Read addr = 0x69. 
 Sequence looks like he indeed sends 0x69, however adaqu1701 doesn't send an ack (pulls SDA low on 9th clock) 
 Attached are read sequence & schematics. 
 Similar write sequence (sending 0x68) produces the required ack. 
 Please advise 
 BR, 
 Alon

DaveThib · Answer

Hello Alon, 
 Yes, it needs a write before a read. That is the way the state machine is setup. You cannot just send a start with the bit set to read. It must be a repeated start after the write setting the read address. 
 Dave T

DaveThib · Answer

Hello Alon, 
 Thought I should explain it a bit more. 
 All I2C commands start with a write followed by the two byte address. 
 Then one of two things can happen: 
 1) If it sees clocks it will continue to accept the data and it knows it is going to write to the address. Then it another byte of clocks arrive without a stop then it will increment the address and stuff the new data into that address. 
 2) If it sees a repeated start followed by its chip address and the "read" bit set, then it will turn the SDA pin over to an output and start shifting out the data in the address it received. Then if it continues to receive clocks with no stop condition it will increment the address and send out the next address. 
 Then finally, a STOP condition will end both of these types of transactions and return the state machine back to its start point. 
 Hope that helps. 
 Dave T

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Challenge Yourself!

What's Brewing

Places

Resources

Visit ContentZone

The Latest Read

New Release

Recent Technical Insights

Products Mentioned

Associated Drivers

Thread Details

ADAU1701 I2C read

Before You Switch