ADAU1452 SDATA_OUT3 SLAVE to CLK DOMAIN 0 does not work


i have a project with an ADAU1452 where SDATA_OUT0 is configured with LRCLK and BCLK as Master. The signal is output on SDATA_OUT0.

SDATA_OUT3 ist configured with LRCLK and BCLK as Slave to CLK domain 0. In this configuration i never get a signal out of SDATA_OUT3.

As i understand the datasheet every output port can be referenced to any clockdomain as slave. This seems to be a very basic task but i don't get it working.

The same behaviour with ADAU1467.

Any idea what i am doing wrong or what i am misunderstanding?

Parents Reply
  • Sorry My reply was for Beni

    Brewster, your question is really determined to how you have wired all the slaves

    I assume all 4 ports are slaves?. if all 4 Master devices are again Clocked from the SAME MCLK then you can choose any of the 4 clock domains (provided all 4 masters  LRCLK /  BCLK are in sync)

    If you set the StartPulse to the "Serial out rate 0" then the DSP is clock at the same rate and you wont need SRC


No Data