1. Check whether the TRST# signal is connected to GND during booting.
2. Make sure that the PLL is configured correctly. The default boot kernel may have the PLL configuration as per the EZ-KIT Lite board. This need to be changed if your application uses a different CLKIN.
3. Make sure that the external port registers are initialized properly. When running the code from emulator, these registers will be initialized by the VDSP++ tools using .xml file. During booting the boot kernel should initialize the external port registers as per the target board used.
4. For more debugging tips please refer the application note(EE-305) on the below link:
1. Check whether the TRST# signal is connected to GND during booting.
2. Make sure that the PLL is configured correctly. The default boot kernel may have the PLL configuration as per the EZ-KIT Lite board. This need to be changed if your application uses a different CLKIN.
3. Make sure that the external port registers are initialized properly. When running the code from emulator, these registers will be initialized by the VDSP++ tools using .xml file. During booting the boot kernel should initialize the external port registers as per the target board used.
4. For more debugging tips please refer the application note(EE-305) on the below link:
