Yes. The debugger allows you to single step over the IDLE instruction in single step mode. This feature is enabled by the emulator interrupt which is also a valid interrupt to release the processor from the IDLE instruction.
- Home
- Blogs ⌵
- Browse ⌵
-
Support ⌵
- 3D ToF Depth Sensing
- Amplifiers
- Analog Microcontrollers
- Analysis Control Evaluation (ACE) Software
- Audio
- Clock and Timing
- Condition-Based Monitoring
- Data Converters
- Design Tools and Calculators
- Direct Digital Synthesis (DDS)
- Embedded Vision Sensing
- Energy Monitoring and Metering
- FPGA Reference Designs
- Industrial Ethernet
- Interface and Isolation
- Low Power RF Transceivers
- MEMS Inertial Sensors
- Motor Control Hardware Platforms
- Optical Sensing
- Power By Linear
- Processors and DSP
- Reference Circuits
- RF and Microwave
- Signal Chain Power (SCP)
- Speech Processing Solutions
- Switches/Multiplexers
- Temperature Sensors
- Video
- Wide Band RF Transceivers
- Wireless Sensor Networks Reference Library
- My EZ
- More
- Cancel
