SC589version please

Hi ,


You need to change the processor settings in CCES as mentioned below.

"Properties > C/C++ Build > Settings > Processor Settings > Processor"

This change is enough to run the SC584 example code into SC589 EZKIT. We are able to run the project"1423.sample_based_SC584"successfully in SC589 EZKIT.

Let us know if you need further assistance.


Regards,
Divya.P

Could you please demonstrate a program that separates the four inputs and four outputs? 

Could you please demonstrate a program that separates the four inputs and four outputs? 

Hi ,

Regarding "Do I have to change all three cores one by one?"
>> Yes, you need to change all the cores one by one.

Regarding "Could you please demonstrate a program that separates the four inputs and four outputs? "
>> Please refer the below FAQ "Sample based code for TDM4 mode using 3.0APIs" which contains an example code for 4 inputs and 4 outputs in TMD mode for ADSP-SC584 processor. As suggested earlier please change the processor settings to ADSP-SC589.

ez.analog.com/.../faq-sample-based-code-for-tdm4-mode-using-3-0apis

Let us know if you need further assistance.

Regards,
Divya.P

Could this example run in the Sigma Studio Plus?
How could I get the phase of two signals in the algorithm added to this section?

Hi,

You can integrate using Sigma Studio for SHARC. For further assistance please post your query in detail on the forum linked below.

ez.analog.com/.../

Regards,

Divya.P