Hello,
I have two problems about programming flash memory.
The two symptoms are related with the size of binary file to be programmed.
For example,
case 1) 336 KB binary: no problem! ok
case 2) 8.2 MB binary: small symptom
In console screen of flash programming batch program, writing process finished well, but verifying process halts.
At that time, I terminate the process and repower board, then it boots ok.
case 3) 21.7 MB binary: critical problem
The verifying process halts as above.
and after repowering, boot fails as SYS_FAULT led on.
The specification of our system is as follows:
DSP: ADSP-SC594
CCES: v2.10.1
emulator: ICE-1000
Flash memory: IS25LP512M (capacity 512Mb = 64MB)
Driver file: is25lp512m_dpia_SC594_Core1.dxe
The content of batch file:
"C:\Analog Devices\CrossCore Embedded Studio 2.10.1\cldp.exe" -proc ADSP-SC594 -core 1 -emu ICE-1000 -driver "is25lp512m_dpia_SC594_Core1.dxe" -cmd prog -erase affected -format bin -file "VC_CM_Core0.ldr" -cmd compare -format bin -file "VC_CM_Core0.ldr"
pause
==The end==
Is there anyone who experiences this problem or can help me?
Thank you in advance.
Best Regards,
Johnny Jeong
