sport

Hi,

Does you configure the SPORT to get the continuous data or single time. If it is continuous, you can’t match the data while checking in breakpoint.
Could you please explain your application in detail. If possible, please share simple project which simulates this issue along with steps you have followed.

Regards,
Divya.P

Hi,

Does you configure the SPORT to get the continuous data or single time. If it is continuous, you can’t match the data while checking in breakpoint.
Could you please explain your application in detail. If possible, please share simple project which simulates this issue along with steps you have followed.

Regards,
Divya.P

Hi,

How to set SPORT for single time,and below is my config code.please check it.

sport_conf.rar

Regards,

Binge

Hi,

Please refer the attached project which configured as single descriptor and in callback we can see the copied data is same as sport buffer. Please set breakpoint in line 114 and check.
4265.SPORT_TDM_Mode.zip
In List of descriptors, data continuously received in SPORT buffer from DAI pin. Even though you have halted processor, data from ADC fills the SPORT buffer continuously. So, data will vary and mismatch happens.

Without breakpoint data will copy correctly. Could you please let us know if you are facing any issues with descriptor list.

Regards,
Divya.P