I used TS201 processor , and now under production phase , after phase out this part which processor almost equivalent processor from ADI ?
Parallel memory map device interface , Please suggest Alternate Part for TS201
Hi Ashok,Can you please let me know what are all the peripherals that you are using in your current design and what are all the peripherals that you would need to carry forward to new design. Note that there no drop in replacement available for the obsolete TigerSharc.Our SHARC processor offers a mix of high performance processing with the large on chip memory and peripheral set in a low cost floating point product. The new series provides designers with end-to-end SHARC family code compatibility and a robust suite of ADI development tools to realize new levels of development efficiency and design innovation via the industry’s highest-performing 32-bit floating point DSP platform.The advanced SHARC Family features, Dedicated hardware accelerators (FIR,FFT,IIR etc), Variable Instruction Set Architecture (VISA) support, additional processing element for Single Instruction, Multiple data (SIMD) support making them particularly suitable for high performance audio applications. Can you please refer the selection tables of SHARC processors, which can be found in the following link.www.analog.com/.../sharc.html The latest ADSP-SC5xx processors are Multicore SHARC+ARM® SOC Delivers 24GFLOPS Performance at Under 2W for AdvancedReal-Time Audio and Industrial Applications. You would find more information about these processors in the below link.www.analog.com/.../adsp-sc58x-adsp-2158x-series.htmlRegards,Anand Selvaraj.
Thank You Very Much for your reply ,
On TS201 Custom board FPGA, AD664,AD9244,BU67301B,29W320EB used in Parallel port interface , and 16k point FFT 1024 Tap FIR used
If i consider SC-589 , which port can i used for parallel devices ?
Hi Ashok,The ADSP-SC589 processors provide an enhanced parallel peripheral interface (EPPI) that supports data widths up to 24 bits. The EPPI is a half-duplex, bidirectional port with a dedicated clock pin andthree frame sync (FS) pins. It can support direct connections to active TFT LCDs, parallel A/D and D/A converters,video encoders and decoders, image sensor modules and other general-purpose peripherals. The ADSP- SC58x processors also supports advanced FFT/FIR/IIR hardware accelerators.For more information on ADSP-SC589, please refer the product page in the below link.www.analog.com/.../adsp-sc589.htmlRegards,Anand Selvaraj.
Can you provide one sample connection /schematics SC-589 interface with NOR Flash
Hi Ashok,Please refer ADSP-SC589 schematic available in the below mentioned link.www.analog.com/.../ADSP-SC589_EZ-Board_Schematic-Rel_2-0B.pdfRegards,Anand Selvaraj.