Blackfin BF561 interface with AD6654

I am using Blackfin BF561 EZ kit to interface AD6654. I made a custom board for ad6654. I am trying to program ad66654 through microport.  to test the setup i have written small program that is testing wrting and reading some address locations of AD6654. but i am not able to read and write these location.

My interface is as follows -

Blackfin                AD6654

Adress( 9 -2)        Adress( 7 -  0 )

Aata ( 15 -0)         Data( 15 -  0 )

SCLK1                 CPUCLK

SMODE              logic 0

Mode                  logic 0

WR\                   AWE\                

RD\                    AOE\

CS\                   AMS1\

I am using bank1 asynchronous memory interface. SCLK1 is about 60MHz. My code is attached for review. Please suggest.

Thanks in Advance

code.txt.zip
Parents
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:18 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:18 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data