Hello,
I'm new with DSP, and I'm preparing for my bachelor thesis in which I would like to use the EZ Kit Lite BF592 Board. Concerning this board I've got several questions:
Does anyone have a "Audio Codec Talkthrough" -Projekt for EZ Kit Lite BF592?
Does anyone have a simple step by step Introduction to make use of the EZ Kit Lite Board/VisualDSP++?
Thanks you very much, I much appriciate your help,
cheers
Hi Guru,
I tried to modify the talkthrough program with microphone enabled. The microphone works fine but there was a noise at about 16kHz. When I remove the mic from J3 on the BF592 EX-KIT, it disappeared.
It seems that this problem only occurs when mic is enabled. This noise exists also when I change the mic gain from SW10.
Best Regards,
Kevin
Hi Guru,
I tried to modify the talkthrough program with microphone enabled. The microphone works fine but there was a noise at about 16kHz. When I remove the mic from J3 on the BF592 EX-KIT, it disappeared.
It seems that this problem only occurs when mic is enabled. This noise exists also when I change the mic gain from SW10.
Best Regards,
Kevin
