2009-02-13 06:39:15 Setting Propagation Segment for BF548 CAN
Patrick Mc Donnell (IRELAND)
I have my CAN working fine on my BF548 and have it running at the desired Baud rate as calculated from the spreadsheet from a different post (see attached).
I calcluated my baud rate using the following equation as seen in attached:
NTQ = 3+SEG1+SEG2
I know that the NTQ = prop seg + TSEG1 + TSEG2.
I can edit TSEG 1 and 2 without any bother but I can't seem to find in any of the header files where the propagation segment is set.
Does anybody know where I can find this.