Which SPI Mode is used by SigmaDSP Devices?

Document created by BrettG Employee on Oct 3, 2012
Version 1Show Document
  • View in full screen mode

The SigmaDSP products (and most devices from Analog Devices with SPI ports) use SPI Mode 3, in which CPOL = 1 and CPHA = 1.

  • CPHA = 1: The data changes on the falling edge of the clock and is read/written on the rising edge of the clock.
  • CPOL = 1: When the bus is idle, the clock signal is high.

 

For reference:

2012.10.03 16.50.00.jpg

(image from Wikimedia Commons, http://commons.wikimedia.org)

 

spi-02.png

(image from Total Phase, http://www.totalphase.com/)

 

This FAQ was generated from the following discussion: Looking for detailed info on adau1961 spi protocol

1 person found this helpful

Attachments

    Outcomes