ADXL345Z-DB: Real-Time Evaluation/Change Settings

Document created by analog-archivist Employee on Feb 23, 2016
Version 1Show Document
  • View in full screen mode

Can I use the EVAL-ADXL345Z-DB for real-time evaluation?

How can I change the settings of the EVAL-ADXL345Z-DB?

 

The EVAL-ADXL345Z-DB datalogger board cannot be used for real-time evaluation.
Acceleration data is stored to an SD card, and is not available to interface to
a PC or other controller for real-time evaluation.

You can download different firmware (to the ADuC7024) to alter the sample rate
and measurement range.

http://www.analog.com/en/evaluation/eval-adxl345z-db/eb.html

Go to Software and Tools. Instructions and software can be found in this
section.

The EVAL-ADXL345Z  breakout board can be used, in conjunction with a PC or
controller, to provide real-time evaluation.

Otherwise the Inertial Sensor Evaluation Board is recommended for real-time
evaluation of ADXL345/ADXL312/ADXL362 devices (and certain ADXRS gyros):

http://www.analog.com/en/mems-sensors/mems-accelerometers/adxl362/products/EVAL-
MST-ALL/eb.html

If you are interested in real-time evaluation of accelerometer data
via a small epaper display (with datalogging capability) you could consider the
ADXL362Z-DB:

http://www.analog.com/en/mems-sensors/mems-accelerometers/adxl362/products/EVAL-
ADXL362/eb.html

Attachments

    Outcomes